Blink
The analogue fire detectors are equipped with a LED which will blink when
the control panel reads the detector status.
Select the Blink option from the SYSTEM
menu (press 2) to enable/disable the de-
tector LED.
Select the loop (L1 or L2) that the LEDs
are connected to. Select ON to enable and
OFF to disable the LED.
Select the address of the detector whose
LED must be enabled/disabled or ...
select the address range (from ... to) of the
detectors whose LEDs must be en-
abled/disabled.
Press the ↵ key to confirm or ESC to exit without saving and step back to
the SYSTEM menu.
Wires
Use the Wire option to specify the configuration of the control panel loops.
Select the Wire option from the SYSTEM
menu (press 3).
Select the configuration of each loop (2 or
4 wires). Press the ↵ key to confirm, or
ESC to exit without saving and step back
to the SYSTEM menu.
PRG: SYSTEM
1=Date/Time 2=Blink
3=Wire 4=SIL 5=WT
6=NET 7=Printer
PRG: SYSTEM
Blinking : L1 S ON
Device : 1/__
From: 1/__ to1/__
PRG: SYSTEM
Blinking : L1 S ON
Device : 1/##
From: 1/__ to1/__
PRG: SYSTEM
Blinking : L1 S ON
Device : 1/__
From: 1/## to1/##
PRG: SYSTEM
1=Date/Time 2=Blink
3=Wire 4=SIL 5=WT
6=NET 7=Printer
PRG: SYSTEM
Wires
Loop 1: 2 wires
Loop 2: 2 wires
PROGRAMMING 67
To Next Page
Loading...
