MODIFYING
The Modifying option from the MAIN menu allows the user to: disable the
devices connected to the control panel; delete the Verify counters and log;
modify some of the parameters of the Telecom module.
Select the Modifying option from the
MAIN menu (press 2).
Enter the user code (the default code is
11111) each digit will be masked by the
symbol Q.
Press the ↵ key to confirm the code. If the
code is valid the display will show the
MODIFYING menu.
Select the required option and refer to the respective section or press ESC
to step back to the MAIN menu.
Wrong code If a wrong code is entered, the display will
request Retry.
User default
code
The user default code is 11111. The user default code may be changed by
means of the PassWD option from the PROGRAMMING menu.
FIRE CLASS 2ØØ
1= Programming
2= Modifying
3= Reading Parameter
Enter
user
code
*****
Modifying:
1=Disable
2=Del.Ver.3=Del.Log
4=Telecom Module
User code
Wrong !
Retry
XXXXX
MODIFYING 81
To Next Page
Loading...
