To enable the Maintenance option, select
ON and enter the date (day, month and
year). The maintenance request will be
signalled by FAULT status on the pro-
grammed date.
Press the ↵ key to confirm, or ESC to exit and step back.
Telephone
The FC200/COM Telecom module (optional) can operate as either a Dial-
ler or Digital Communicator ---- or both. The properly programmed Tele-
com module will be activated by ALARM, WARNING, PREALARM and
FAULT events, and will send voice messages and/or data to the pro-
grammed telephone numbers. By entering the installer code (Factory de-
fault 00000) and pressing the ↵ key it will be possible to stop ongoing calls,
and clear the call queue.
Select the Tel option from the PROGRAM-
MING menu (press 0).
Autolearning not done ---- the display will
show the Module not present message.
Autolearning done ---- the display will
show the PRG: TELECOM MODULE
menu.
Select the required option, as per the fol-
lowing chart and continue, or press ESC to
step back to the PROGRAMMING menu.
KEYS OPTIONS
1 Dial.
2 Commun.
3 T.Num.
4 Option
5 Remote Management
PRG: FACTORY
Maintenance
Maintenance : OFF
on date ØØ/ØØ/ØØ
1=Auto 2=Devices
3=PassWD 4=MesINI
5=Zones 6=Opt 7=Sys
8=Ver 9=Def Ø=Tel
PRG: TELECOM MODULE
Module
not present
Esc to Quit
PRG: TELECOM MODULE
1)Dial. 2)Commun.
3)T.Num. 4)Option
5)Remote Management
PROGRAMMING 73
To Next Page
Loading...
