Disable
The Disable option from the MODIFYING menu can disable or Enable:
Ø the loop devices (input or output devices);
Ø Bell Outputs;
Ø Software Zones;
Ø Devices on the Network (repeater panels or slave panels).
The DISABLE LED will go ON when one or more of the above mentioned
is/are disabled.
The disabled and enabled modes are as follows.
Input Devices A disabled input device (Detector, Input module, Conventional Zone mod-
ule, Addressable Call-points) will not generate ALARM or FAULT status.
Ø To clear FAULT status generated by an input device - Disable the input
device concerned.
Ø To clear ALARM status generated by a input device - RESET the control
panel.
+
Input devices enabled during ALARM or FAULT status will generate the
status, as necessary.
Output Devices ALARM or FAULT status will not activate disabled output devices (Output
modules, Addressable Sirens).
Ø To stop the output devices activated by FAULT status - Disable the de-
vices concerned.
Ø To stop the output devices activated by an ALARM status - RESET the
control panel.
+
Output devices enabled during ALARM or FAULT status, will be activated
immediately.
Bell Outputs The enabled and disabled operating modes of the Bell Outputs are as per
output devices.
Software Zones The disabled or enabled mode of a software zones will effect all its associ-
ated devices, as previously described.
Repeaters A disabled repeater panel cannot command the Master control panel, al-
though, its display will show the Master panel status. FAULT status will be
generated when a repeater panel is Not Found. Loss of a disabled re-
peater panel will not generate a FAULT status.
Ø To clear a FAULT status - generated by the loss of a Repeater - Disable
the repeater panel concerned.
82 Analogue Fire Control Panel FireClass200
To Next Page
Loading...
