Bentel Security FireClass 200 - Reading Parameter; Devices;Zones;Outputs

READING PARAMETER
Use the Reading Parameter option from the MAIN menu to view all the
control panel parameters, and to print the log contents.
Select the Reading Parameter option
from the MAIN menu (press 3). No access
code is required, as viewing and printout
do not effect the parameters and operating
modes of the control panel.
The display will show the READING PA-
RAMETER menu.
Select the required option and refer to the respective section, or press
ESC to step back to the MAIN menu.
Devices/Zones/Outputs
The Dev./Zones/Outputs option from the READING PARAMETER menu
shows the parameters of the devices connected to the Loops, Software
Zones, Bell Outputs, and of the devices on the network.
1. Select the Dev./Zones/Outputs option
from the READING PARAMETER menu
(press 1) or press ESC to step back to the
MAIN menu.
2. Select the required option or press ESC to
return to the READING PARAMETER
menu (step 1.).
3. Enter the address of the required Item.
Press ESC to step back to the
Dev./Zones/Network (step 2.).
FIRE CLASS 2ØØ
1= Programming
2= Modifying
3= Reading Parameter
READINGS:
1=Dev./Zones/Outputs
2=Opt.3=Ver.4=Log.
5=Print 6=M.Telecom
READINGS:
1=Dev./Zones/Outputs
2=Opt.3=Ver.4=Log.
5=Print 6=M.Telecom
RD: Choosing Menu
1=LOOP 1 2=LOOP 2
3=Outputs BELL
4=ZONES 5=NET
RD: Devices L1
Enter Address
Sensors L1: 1/##
Modules L1: 1/__
READING PARAMETER 87