PROGRAMMING
Press 1 to access the PROGRAMMING
menu from the MAIN menu.
Type in the installer code (00000 at de-
fault). Each digit will be masked by the
symbol Q.
Press the ↵ key to confirm the code.
The display will show the PROGRAM-
MING menu.
Select the required option and refer to the
respective section for instructions.
Wrong code If you enter a wrong code, the system will
prompt you to Retry.
Default Installer
code
To change the installer code (00000 at default), refer to the "Password
(PassWD)" section.
RAM disabled If the jumper 9 is not connected the dis-
play will show the RAM Disabled mes-
sage.
FIRE CLASS 2ØØ
1= Programming
2= Modifying
3= Reading Parameter
Enter
installer
code
*****
1=Auto 2=Devices
3=PassWD 4=MesINI
5=Zones 6=Opt 7=Sys
8=Ver 9=Def Ø=Tel
Installer code
wrong !
Retry
XXXXX
Writing
RAM
Disabled !
Act on internal DIP
PROGRAMMING 39
To Next Page
Loading...
