Ø If parameter changes were made prior to power loss, the following mes-
sages will be shown intermittently.
From this status it will be possible to access control panel management by
pressing any button except RESET and TEST.
Ø If autolearning was done prior to power loss, the following message will be
shown.
From this status it will be possible to access control panel management by
pressing any button except RESET and TEST.
Maintenance
Carry out the following operations periodically.
1. Remove dust with a damp cloth (use water only).
2. Clean the Plexiglas window with a damp cloth (use water only). Do not
clean the control panel keypad, as you may accidentally activate a
command.
3. Press the TEST button to check the LEDs and the Buzzer.
4. Check the batteries.
5. Check all connections.
6. Check that the inside of the control panel cabinet is free from obstructions.
+
Steps 4., 5. and 6. must be carried out by qualified persons only.
FIRE CLASS 2ØØ
No Devices
acquired
ØØ:ØØ 23/11/98 Mon
FIRE CLASS 2ØØ
Hit a Key
to take
control
FIRE CLASS 2ØØ
Scanning Loop
>> >> >>
ØØ:ØØ 23/11/98 Mon
INSTALLATION 33
To Next Page
Loading...
