↵ Use the ↵ key to confirm and save changes and to step forward or back.
Editing a Text Read this section carefully to get an overall view of the steps involved in
creating strings (e.g. Labels).
Ø Use the ← and → keys to scroll along the line.
Ø Press the respective key until the required letter is shown.
Ø Use the ↑ key for upper-case letters and the ↓ key for lower-case letters.
Ø Use key 9 for punctuation marks (full-stop, comma and dash) and spaces.
Once the text has been completed, press the ↵ key to confirm and step for-
ward, or position the cursor on the first letter of the text then press the ←
key to step back.
# The display examples show the default values (refer to Analogue values).
The # symbol indicates that the respective parameter has no default value
setting.
36 Analogue Fire Control Panel FireClass200
To Next Page
Loading...
