General Explanation Repair
Messages
contact between embroidery computer
and embroidery module is interrupted
due to vibrations
⦁
reconnect embroidery module and switch off and on the
embroidery computer
winding a bobbin
too much fabric under presser foot
⦁
wind bobbin as shown in the animations
⦁
reduce amount of fabric under presser foot
needle position doesn‘t correspond to
center of hoop
bobbin is inserted incorrectly
bobbin cover is not closed
no bobbin is inserted
threader does not move to starting
position
⦁
calibrate according to User Instructions page 57
⦁
turn over the bobbin, white markings must be visible
⦁
close the bobbin cover slowly
⦁
insert the bobbin
⦁
push the threader carefully to the top
To Next Page
Loading...
