Biolight Meditech P1 - Page 210

P1 Patient Monitor User’s Manual
17-7

1. Select【Main Menu】quick keyfrom【Report】column to select【Report
Setup】.
2. Select desired reports.
3. Check the setting.
4. Select 【Print】.
17.3.4. Automatically Printing Report
You can start printing automatically when you set parameter alarm. To do so,
follow this procedure:
1. Select parameter alarm related menus such as 【Alarm】 submenu in one of
the following ways:
 Select 【Alarm Setup】 quick key.
 Select the parameter or waveform area of the desired
parametersselect alarm related menus.
 Select the 【 Parameters Setup 】 quick keyselect desired
parametersselect alarm related menus.
2. Switch on 【Switch】 and 【Alarm output】 of desired parameters. If an
alarm of the parameter occurs, the printer will automatically start to print
the measurement data of the parameter.
17.3.5. Setting the Reports
This section described how to set ECG reports, realtime reports, tabular trends
reports and graphic trend reports.
17.3.5.1. Setting ECG Reports
To set ECG report, follow this procedure:
1. Select【Main Menu】quick keyfrom【Report】column to select【Report
Setup】.
2. Select 【ECG Report】.
3. Set the desired items. The following table only lists some of the options.