Biolight Meditech P1 - Page 43

P1 Patient Monitor User’s Manual
3-13 

WARNING：
 Verify the settings of brightness, alarm volume, QRS volume and key tone
before entering the night mode. Pay attention to the potential risk if the setting
value is low.
3.6.5.2. Exit the Night Mode
To exit the night mode, follow this step:
1. Press【Exit Night Mode】quick key or select【Main Menu】quick keyfrom
【Display】column to select【Exit Night Mode】button.
2. In the pop-up box to select【OK】..
NOTE
：
The monitor resumes the previous settings after exiting the night mode.
3.6.6. Privacy Mode
The privacy mode is a special monitoring mode. In the privacy mode, the monitor
does not display patient information and monitoring data to protect patient information
from non-clinicians such as visitors.
The privacy mode is only available when the patient admitted by the monitor is also
monitored by the Central monitoring system. The monitor continues monitoring the
patient, but patient data is only visible at the Central monitoring system.

3.6.6.1. Entering the Privacy Mode
To enter the privacy mode, choose either of the following ways:
 Select 【Main Menu】 quick keyfrom the【Display】column to select
【Privacy Mode】buttonSelect【OK】.
The monitor has the following features after entering the privacy mode:
 The screen turns blank, and prompt 【Being monitoring】at same time.
 All parameters and waveforms display are shield.
 Except for the low battery alarm, the monitor inactivates alarm tone and alarm