Bosch B9512G - User Command 9; Bypass a Point; Unbypass a Point; Reset Sensor(S)

Control Panel User Configuration | en 167
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
Allow a user with this authority level to report User Command 7 reports if the area to which
this authority level is assigned sends User Command 7 reports.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > User Command 7
9.4.28 User Command 9
Default:
Authority Levels 1: Enabled (E)
Authority Level All others: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.
– Enabled (E): This function is authorized for the user who is assigned this authority level.
Allow a user with this authority level to report User Command 9 reports if the area to which
this authority level is assigned sends User Command 9 reports.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > User Command 9
9.4.29 Bypass a Point
Default:
Authority Levels 1-4, 15: Enabled (E)
Authority Levels 5-14: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.
– Enabled (E): This function is authorized for the user who is assigned this authority level.
This parameter allows the user with this authority level to bypass points.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > Bypass a Point
9.4.30 Unbypass a Point
Default:
Authority Levels 1-4, 15: Enabled (E)
Authority Levels 5-14: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.
– Enabled (E): This function is authorized for the user who is assigned this authority level.
This parameter allows the user with this authority level to unbypass points.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > Unbypass a Point
9.4.31 Reset Sensor(s)
Default:
Authority Levels 1-4, 15: Enabled (E)
Authority Levels 5-14: Blank (-)