Bosch B9512G - Sim Pin; Network Access Point Name (APN)

Control Panel SDI2 modules | en 249
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
Default: 0
Selections: 0-3600 (seconds)
– 0 - Disabled.
– 1 to 3600 - Enabled.
When there are no towers present the control panel starts two timers, one for a
NoTowersevent, one for a NoIPAddress event. The control panel uses the duration set by
this ReportingDelayforNoTowerparameter for both timers. If the cellular plug-in module
does not find a tower before the end of the delay, the control panel creates a NoTowersevent
and a NoIPAddressevent at the same time.
The control panel creates a NoTowerrestoral event when one or more towers are available for
the duration set by this ReportingDelayforNoTowerparameter.
The contro panel creates a NoIPAddressrestoralevent when the cellular plug-in module
successfully registers with one or more towers and receives an IP address.
Notice!
When one or more towers are available, 60 second delay for NoIPAddressevent
If the cellular plug-in module successfully registers with one or more towers, but does not
receive an IP address within 60 seconds, the control panel creates a NoIPAddressevent.
RPS menu location
SDI2 modules > IP Communicator > B450 Cellular > Reporting delay for no towers
14.5.7 SIM PIN
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: Blank
Selections: 4-8 numbers
This is an optional parameter. This parameter is only necessary if the SIM card uses a PIN for
security.
The SIM PIN is hidden on the display and appears as asterisks (********) when entered. If an
invalid SIM PIN is entered, an event is logged in history. A report is sent only if the report
function is enabled. If no SIM PIN is required, you can leave the field blank.
RPS menu location
SDI2 modules > IP Communicator > B450 Cellular > SIM PIN
14.5.8 Network Access Point Name (APN)
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: wyless.apn
Selections: 0-99 ASCII characters