184 en | Points Control Panel
2017.03 | 09 | F.01U.303.998 Program Entry Guide Bosch Security Systems, Inc.
5. Alarm Verification: A Fire point can delay an alarm by the time programmed in Restart
Time in the Area parameters. Combined with Resettable, a fire point also resets the
electrical circuit for the amount of Restart Time.
6. Reset Sensor: A fire device that requires resetting can be manually reset using the reset
sensor output for the area it is assigned to.
7. Fire Walk: Use the Fire Walk function to test fire points in the system.
To provide an audible tone for a Fire Supervisory point that has been restored, use Output
Response Type and connect to a graphic annunciator.
You should dedicate a Fire annunciation device to all your fire points if they are assigned to a
single area in a multiple area system.
10.3.4 Point Type
Point Response, page 184
Circuit Style, page 202
Default:
– Point Indexes 1 to 2, 6, 23, 31: 24 Hour
– Point Indexes 3 to 5, 22: Fire Point
– Point Indexes 7-9, 20, 21, 24-27: Part On
– Point Index 10-12, 29-30: Interior
– Point Index 13, 28: Interior Follower
– Point Index 14: Keyswitch Maintained
– Point Index 15: Keyswitch Momentary
– Point Index 16: Open/Close Point
– Point Index 17, 18: Gas Point
– Point Index 19: AUX AC Supervision
Selections: (click the links below for a description of each point index)
– 24-Hour, page 203
– Part On, page 203
– Interior, page 204
– Interior Follower, page 204
– Keyswitch Maintained, page 205
– Keyswith Momentary, page 205
– Open / Close Point, page 205
– Fire Point, page 206
– Aux AC Supervision, page 206
– Gas Point, page 206
– Custom Function, page 206
This parameter defines the point type.
RPS Menu Location
Points > Point Indexes > Point Type / Response / Circuit Style
10.3.5 Point Response
Default:
Point Profile
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Point Response Default 0 1 1 1 1 9 0 8 9 0 8 9 8 1 1 1
To Next Page
Loading...
