Control Panel Panel Wide Parameters | en 43
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
This parameter assigns a port number for the destination the RSC application uses to
communicate with the camera and view live video feed.
If the live viewer URL is assigned to a router, configure the router with the value specified
here.
Notice!
When using HTTPS, set this parameter to 443.
The B9512G supports Cameras 1 to 16. The B8512G supports Cameras 1 to 8.
RPS Menu Location
Panel Wide Parameters > IP Cameras > Live (Video) > Port #
3.7.2 Use HTTPS?
Default: No
Selections:
Yes - Enable HTTPS
No - Disable HTTPS
Use this parameter to encrypt data for a secure network communications between the Bosch
IP camera and the RSC.
Set to "Yes" if the live viewer requires HTTPS.
Notice!
When using HTTPS, set Panel Wide Parameters > IP Cameras > Live (Video) > Port # to 443.
The B9512G supports Cameras 1 to 16. The B8512G supports Cameras 1 to 8.
RPS Menu Location
Panel Wide Parameters > IP Cameras > Live (Video) > Use HTTPS?
3.7.3 User Name
Default: live
Selection: Enter up to 32 characters.
This parameter specifies the user name that the RSC application uses to show video from the
camera.
The B9512G supports Cameras 1 to 16. The B8512G supports Cameras 1 to 8.
RPS Menu Location
Panel Wide Parameters > IP Cameras > Live (Video) > User Name
3.7.4 Password
Default: Blank
Selections: 0-32 characters
This parameter sets the password required by the RSC application to view video from the
camera. The password is case sensitive.
The B9512G supports Cameras 1 to 16. The B8512G supports Cameras 1 to 8.
RPS Menu Location
Panel Wide Parameters > IP Cameras > Live (Video) > Password
To Next Page
Loading...
