Bosch B9512G - Point Profiles; Point Profile Text (First Language)

182 en | Points Control Panel
2017.03 | 09 | F.01U.303.998 Program Entry Guide Bosch Security Systems, Inc.
Selections: 5-255 (seconds)
The Cross Point Time is the duration of the cross point window or the amount of time the
control panel waits for a second point within the same cross point group to fault before
generating an Cross Zone Alarm event. If a second point is not faulted within the Cross Point
Time, then a Burglar Alarm event is generated.
Only use the Cross Point function on non-fire points.
Notice!
Cross points must be overlapped so that each individual cross point can protect the area
individually
RPS Menu Location
Points > Cross Point Parameters > Cross Point Timer
10.3 Point Profiles
Point profiles (point indexes) determine how the control panel responds to changes on points.
To build point profiles, use the parameters in this section. Assign Point Profiles to points in
Point Assignments.
10.3.1 Point Profile Text (First Language)
Default:Refer to table below
Selections:Up to 24 alphanumeric characters
Enter up to 24 characters of text to describe the point profile (point index).
Point
Profile #
Point Profile text Point
Profile #
Point Profile text
1 24-Hour Instant Open/Short 17 Gas
2 24-Hour Invisible/Silent on
Short
18 Gas Supervisory
3 Pull Station 19 Aux AC Supervision
4 Smoke Detector 20 Part On: Watch Off
5 Smoke Detector with
Verification
21 Part On: POPIT Motion
6 Bell Supervision - D192G 22 Fire Supervisory on Op
7 Part On: instant 23 Non-Fire Supervisory Op
8 Part On: Delay 24 Local Buzz on Fault
9 Part On: Instant, Local
Disarmed, Buzz
25 Part On: Delay Watch Off
10 Interior: Instant 26 Part On: Instant (2)
11 Interior: Delay 27 Part On: Delay (2)
12 Interior: Instant Local
Disarmed
28 Interior Follower (2)
13 Interior: Follower 29 Interior Instant (2)