Bosch B9512G - RPS Reports; Point Reports

56 en | Panel Wide Parameters Control Panel
2017.03 | 09 | F.01U.303.998 Program Entry Guide Bosch Security Systems, Inc.
Auto Function Reports
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Sked Changed Yes Yes Yes No
Fail to Execute Yes Yes Yes No
Selections:
– Yes - assign this report to the Route Group.
– No - do not assign this report to the Route Group.
RPS Menu Location
Panel Wide Parameters > Report Routing > Auto Function Reports.
3.9.10 RPS Reports
Default:
RPS Reports
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Event Log Threshold Yes Yes Yes No
Event Log Overflow Yes Yes Yes No
Parameters Changed Yes Yes Yes No
RPS Access OK Yes Yes Yes No
RPS Access Fail No No No No
Remote Reset Yes Yes Yes No
Program Access OK Yes Yes Yes No
Program Access Fail Yes Yes Yes No
Selections:
– Yes - assign this report to the Route Group.
– No - do not assign this report to the Route Group.
RPS Menu Location
Panel Wide Parameters > Report Routing > RPS Reports.
3.9.11 Point Reports
Default:
Point Reports
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Service Start Yes Yes Yes No
Service End Yes Yes Yes No
Fire Walk Start Yes Yes Yes No
Fire Walk End Yes Yes Yes No
Walk Test Start Yes Yes Yes No
Walk Test End Yes Yes Yes No
Extra Point Yes Yes Yes No