Bosch B9512G - Session Keep Alive Period (Min.); Inactivity Time out (Min.); Reporting Delay for Low Signal Strength (Sec.)

Control Panel SDI2 modules | en 247
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
14.5.2 Session Keep Alive Period (min.)
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: 0
Selections: 0 to 1000 (minutes)
– 0 - Disabled. Panel does not verify the connection is active.
– 1 to 1000 - Enabled. Panel verifies an active connection exists.
This parameter sets the length of time in minutes between session keep alive reports to verify
that an idle connection is still active. This parameter is pre-configured for optimal
performance. Leave at the default setting. Default settings should only be changed for high
security UL1610 commercial listed installations requiring low signal notification.
RPS menu location
SDI2 modules > IP Communicator > B450 Cellular > Session keep alive period
14.5.3 Inactivity Time Out (min.)
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: 0
Selections: 0 to 1000 (minutes)
– 0 - Disabled. Panel does not verify the connection is active.
– 1 to 1000 - Enabled. Panel verifies an active connection exists.
This parameter specifies the time before the control panel will disconnect a session with no
data traffic. This parameter is pre-configured for optimal performance. Leave at the default
setting. Default settings should only be changed for high security UL1610 commercial listed
installations requiring low signal notification.
RPS menu location
SDI2 modules > IP Communicator > B450 Cellular > Inbound SMS
14.5.4 Reporting Delay for Low Signal Strength (sec.)
Notice!
Important configuration information for cellular communication
Refer to Configuring for Cellular Service, page 280 for an overview and configuration
information.
Default: 0
Selections: 0-3600 (seconds)
– 0 - Disabled.
– 1 to 3600 - seconds of delay before Cellular Low Signal event.