Bosch B9512G - Cancel Reports; Call for Service Text - First Language; Call for Service Text - Second Language

Control Panel Panel Wide Parameters | en 75
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
The duress alarm is activated when a user enters the duress combination followed by the
termination keys (ESC or ENT).
RPS Menu Location
Panel Wide Parameters > Miscellaneous > Duress Type.
3.15.2 Cancel Reports
Default:Yes
Selections:
– Yes - send Cancel, Fire Cancel and Gas Cancel reports according to Routing.
– No - do not send Cancel, Fire Cancel and Gas Cancel reports.
Use this parameter to determine whether or not Cancel, Fire Cancel and Gas Cancel reports
are sent.
Notice!
SIA CP-01 False Alarm Reduction requirement
To comply with SIA CP-01 False Alarm Reduction, set this parameter to Yes. Refer to SIA
CP-01 Verification for more information.
A Cancel, Fire Cancel and Gas Cancel report is created when a passcode is entered to silence
an Alarm Bell, Gas Bell or a Fire Bell before the bell time expires.
RPS Menu Location
Panel Wide Parameters > Miscellaneous > Cancel Reports
3.15.3 Call for Service Text - First Language
Default: Contact your dealer
Selections: Enter up to 32 characters.
This parameter allows the user to customize the Call for Service message that is displayed at
keypads.
Enter up to 32 characters of text, numbers and symbols.
Keypads display the first 20 characters. If more than 20 characters are used, the text scrolls
across the display one time. To scroll the text again, press [ESC].
Spaces before, after and within a string of text are treated as text and are included in the 32
character limit.
Note: First and Second languages are programmed during panel account setup in the Panel
Data window. Supported languages include English, Spanish, French and Portuguese. To view
the languages selected during account set-up, refer to Panel Wide Parameters > Personal
Notification > User Language.
RPS Menu Location
Panel Wide Parameters > Miscellaneous > Call for Service Text - English
3.15.4 Call for Service Text - Second Language
Default: Blank
Selections: Enter up to 32 characters.
This parameter allows the user to customize the Call for Service message that is displayed at
keypads.
Enter up to 32 characters of text, numbers and symbols.
Keypads display the first 20 characters. If more than 20 characters are used, the text scrolls
across the display one time. To scroll the text again, press [ESC].
Spaces before, after and within a string of text are treated as text and are included in the 32
character limit.