Bosch B9512G - Part on Open;Close; Send Duress; Arm by Passcode

Control Panel User Configuration | en 171
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
RPS Menu Location
User Configuration > Authority Levels > Restricted Open/Close
9.4.41 Part On Open/Close
Default:
Authority Levels 1 - 14: Enabled (E)
Authority Level 15: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.
– Enabled (E): This function is authorized for the user who is assigned this authority level.
Allow a user with this authority level to report Part On opening and closing reports if the area
to which this authority level is assigned sends Part On opening and closing reports.
Authority Level 15 is reserved for the Service Passcode (User 0) and cannot be changed.
RPS Menu Location
User Configuration > Authority Levels > Part On Open/Close
9.4.42 Send Duress
Default:
Authority Level 14: Enabled (E)
Authority Levels 1-13, 15: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.
– Enabled (E): This function is authorized for the user who is assigned this authority level.
Allow a user with this authority level to send duress report if the area to which this authority
level is assigned sends duress. Refer to Duress Enable for more information.
Configure the Duress Enable parameter to Yes in applicable areas, or the keypad will respond
with No Authority.
Duress Disarm Profile
User Authority Level 14 is programmed by default as a Duress disarm profile. When Duress
Type is set to 3, the SIA CP-01 compliant Duress Passcode feature is enabled. Duress Types 1
and 2 are not allowed in SIA CP-01 compliant installations.
With Authority Level 14 assigned to a user passcode in an area, that user has the authority to
disarm and send a Duress event from that area.
All Duress-capable passcodes must be unique and cannot be derived from other passcodes.
To facilitate this uniqueness, User Authority Level 14 is pre-programmed from the factory as
an example of Duress Disarm authority.
A Duress Disarm user authority level requires the following functions to be enabled:
– Disarm Select, page 158
– Send Duress, page 171
– Disarm by Passcode, page 172
RPS Menu Location
User Configuration > Authority Levels > Send Duress
9.4.43 Arm by Passcode
Default:
Authority Levels 1-6: Enabled (E)
Authority Levels 7-15: Blank (-)
Selections:
– Blank(-): This function is not authorized for the user who is assigned this authority level.