Bosch B9512G - Buzz on Fault; Watch Point

Control Panel Points | en 193
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
RPS Menu Location
Points > Point Indexes > Invisible Point
10.3.12 Buzz on Fault
Default:
– Point Index 9: 1
– All other Point Indexes: 0
Selections:0 to 3
This parameter brings attention to a faulted point by generating a trouble buzz even if the
point is not actually in trouble.
Instant Alarm (I), Trouble (T) and Supervisory (S) point responses take priority over Buzz on
Fault. If the point response is "blank", then Buzz on Fault can be the only response. Refer to
the Point Response, page 184 configuration for a description of response types for each point
type and how they are affected by arm state.
If an alarm, trouble or supervisory event occurs and is silenced, then Buzz on Fault selections
1 and 3 will persist until the point returns to normal.
Refer to the following table for Buzz on Fault controlled point operation and 24-hour point
operation:
Selection Buzz on fault Silence while
faulted
Silence after
restore
Description
0 Disabled Does not apply Does not apply Buzz on Fault
feature is
disabled.
1 Yes Not allowed Allowed Buzz persists
until the point
restores and is
silenced.
2 Yes Allowed Allowed Buzz can be
silenced.
3 Yes Not allowed Auto silence Buzz persists
until the point
restores.
Notice!
Custom Function point types do not support Buzz on Fault.
RPS Menu Location
Points > Point Indexes > Buzz on Fault
10.3.13 Watch Point
Default:
– Point Indexes 7 to 8: Yes
– All other Point Indexes: No
Selections: