Bosch HTD 8 Series - Product description; Light box; Control panel

1 692 104 611 2014-10-15| Robert Bosch GmbH
Product description | HTD 8xx | 27 en
3.4.2 Light box
The light box contains the components for checking
and setting vehicle headlamps.
Fig. 2: Light box
1 Bolt for securing control panel
2 Control panel
3 Spirit level for horizontal alignment
4 Sliding block for height adjustment
5 Graduated scale
6 Jack for battery charger
7 On/Off switch
8 Serial interface
9 USB interface
10 Optional: Printer
The control panel is fixed in position by means of a bolt
and can be turned through 180° if required.
The light box contains a laser unit for finding the centre
of the headlamp. A laser cross is projected onto the
headlamp for this purpose.
3.4.3 Control panel
The beamsetter is operated by way of visualisation on
the control panel (with touch screen).
Fig. 3: Control panel with touch screen
Fig. 1: Components
1 Alignment laser
2 Control panel with touch screen
3 Light box
4 Column
5 Trolley
6 Handle on the column
7 Handle
R Alignment laser:
For alignment of the device with the vehicle.
R Control panel:
Contains an LCD colour monitor with touch screen.
Visualisation permits the simple implementation of
a range of functions. The operator is guided through
the headlamp test procedure.
R Light box:
Mounted on the column; height can be adjusted with
one hand.
R Column:
Can be turned through approx. 30°, for alignment
with the vehicle. The column is provided with a
centimetre scale for exact positioning of the light
box with respect to the headlamp. A counterweight
is attached to a rope in the column (for adjustment
of light box height).
R Trolley:
For moving the device. Three of the four wheels are
height-adjustable.