Bosch HTD 8 Series - Operation; Starting test; Test result; Conclusion of testing

1 692 104 611 2014-10-15| Robert Bosch GmbH
38 | HTD 8xx | Operationen
5.8.2 Starting test
After entering the vehicle settings, a mask appears for
selecting the headlamp to be tested.
Fig. 40: Selecting headlamp
1. Click onto the symbol for the headlamp to be tested:
$ Low beam left or right
$ High beam left or right
$ Fog lamp left or right.
 The mask for starting individual testing appears.
Fig. 41: Starting individual testing (example)
The display shows the selected headlamp (right dipped
beam in example in Fig. 41).
2. Switch on the specified headlamp.
3. Press the symbol Start measurement to
commence testing.
The test procedures are described in the following
Sections:
R Low beam: Refer to Sec.5.7.2 auf Seite 34
R High beam: Refer to Sec.5.7.3 auf Seite 35
R Fog lamp: Refer to Sec.5.7.4 auf Seite 36
Headlamp test can be terminated by the user after each
test (not all headlamps have to be tested) and a report
called up by pressing the symbol.
5.8.3 Test result
On completion, the test result is indicated by a
coloured dot in the symbol for the corresponding
headlamp:
Fig. 42: Specimen test result: Right low beam
R Green dot: Headlamp already checked, result OK
R Red dot: Headlamp already checked, result not OK
5.8.4 Conclusion of testing
After testing the desired headlamps on both sides of
the vehicle, the results are presented on the display
(coloured dots in the headlamp symbols, refer also to
Fig. 42).
Fig. 43: Specimen test results (all headlamps checked)