Bosch HTD 8 Series - Setting options; Display; Firmware update; Info

1 692 104 611 2014-10-15| Robert Bosch GmbH
40 | HTD 8xx | Setting optionsen
6.2 Display
This mask can be used to specify the period of time
without entries after which the display is deactivated.
1. Open up the mask: Click onto Options in the start
mask.
2. Click onto DISPLAY in the Options mask.
Fig. 47: Setting the display
3. Select the desired option:
$ "Off": The display always remains active
$ "1m": The display is deactivated after 1 minute
without any entries being made
$ "5m": The display is deactivated after 5 minutes
without any entries being made.
$ "Adj. Mode": Display unit mounted to the front
$ "PTI Mode": Display unit mounted to the rear
4. Confirm with .
"The display is then deactivated after the selected time
without any entries being made. The "Options" mask
appears.
6.3 Firmware update
! This function is only to be executed if new firmware
(FW) is available. The system could be damaged if
use is made of a USB stick not containing FW.
This mask can be used to update the device firmware.
1. Open up the mask: Click onto Options in the start
mask.
2. Click onto FW in the Options mask.
Fig. 48: Updating FW
3. Insert the USB stick with the new firmware in the
USB interface on the side of the light box.
4. Click onto Update and wait for completion of
updating.
5. Remove the USB stick.
6. Confirm with .
"The device firmware has been updated. The "Options"
mask appears.
6.4 Info
This mask shows information on the device.
1. Open up the mask: Click onto Options in the start
mask.
2. Click onto INFO in the Options mask.
Fig. 49: Device information