Bosch IRIS-Net - Page 118

Function Parameter Opt.Value Invert Triggering Event/Status Change
Empty - - Not configured
Power
X
Power On
Power Off (Standby)
Absolute all DSP parameters Corresponding
Parameter Value
(parameter-
dependent)
X
Set parameter value reached or
exceeded Set parameter value
declined
Temp Temperature in °C
X
Set temperature reached or exceeded
Set temperature declined
VU IN A, IN B, OUT A, OUT B, Amp
Limiter A/B, DSP
Limiter A/B, Compressor A/B
Level in dB
X
Set level reached or exceeded Set level
declined
GPI IN 1, IN 2
X
Control input 1 / 2 closed (ON)
Control input 1 / 2 open (OFF)
Errorflag All internal fault conditions
X
Single or several error flags set None
of the selected error flags set
Memoflag Enable for selected flags as
well as bit-pattern of flags 1 -
16
X
Memory flags match the selected bit-
pattern Memory flags do not match the
selected bit-pattern
Preset U01 - U08, F01
X
Specified preset selected
Other than the specified preset
selected
IRIS-Net
REMOTE AMPLIFIER | en 118
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956