.../PRM/CHAN A / B / A,B Selects channel A, or channel B, or channel A
and B
../PRM/IDX 00...FF Selects the DSP parameter via index number
PRESET Loads a DSP preset
../PRM/NR U1...U6,
F1...F2,
O1...O2
Selects an user preset User Preset (Ux), a
Factory Preset (Fx) or a Owner Preset (Ox)
MONI Controls the selection for the audio monitoring
bus
../PRM/SEL NONE,
RELAY, IN_A,
OUT_A, IN_B,
OUT_B
Selects audio monitoring parameters. All
combinations are possible.
../PRM/SWITCH ON, OFF Switches the selected audio monitoring
parameter ON or OFF
MEMFLA
G
Manipulates general Memo flags
../PRM/CLR NONE, 1...16 Clears selected flags
../PRM/TOGGLE NONE, 1...16 Changes the state of selected flags. Use CLR and
TOGGLE together, so that selected flags are set
afterwards.
MEAS Initiates impedance testing at a fixed frequency
../PRM/CHAN A / B / A B Selects channel A, or channel B, or channel A
and B
../PRM/FREQU 10...20000
[Hz]
Generator frequency for impedance test
../PRM/LEVEL -128...+50
[dBu]
Generator level for impedance test
../PRM/TIME 0.0,
0.1...1000
[ms]
Impedance test time span. 0.0 = continuously ON
../PRM/Q 0.0...60 Quality of band pass filter
../PRM/MIX ON, OFF Wanted signal and Generator signal mixed
../PRM/PRE ON, OFF Generator signal fed in at the input (ON) or
output (OFF) of the DSP signal chain
TESTGEN Defines parameters for the audio testing
generator
../PRM/
INPCHAN
A / B / A,B Selects input channel A, or input channel B, or
input channel A and B
IRIS-Net REMOTE AMPLIFIER | en 234
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
