Manually setting or resetting an error.
Clears the indication of errors for which HOLD had been activated. Indication
of still existing errors is not reset.
CAN INTERFACE FAULTS
Error Description
CAN FAILURE CAN self-testing was not successful. The CAN-Bus does not function.
CAN BUS OFF The CAN-Bus is in the "Bus OFF" state.
CAN BUS PASSIVE The CAN-Bus is in "Passive" mode.
REMOTE AMPLIFIER CONFIG The RCM configuration does not represent the RCMs that are actually connected.
REMOTE AMPLIFIER FAULT Collected Error for at least one RCM has been set.
FAN SPEED
Speed
Description
0 Off
1 Slow
2 Med
3 High
IRIS-Net
DIGITAL MATRIX | en 332
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
Need help?
General
