Set Amplifier Preset: Execution of this macro loads the selected Preset into memory of a single or a variety of power
amps. Amps specified in the amplifier list as „Amplifier X“ represent remote amps with CAN address „X“ that are
connected to the CAN bus.
Digital Output: Execution of this macro changes the (digital) state of a control output of the N8000. It is possible to
– set (relay contact closed, i.e. connected to ground),
– reset (relay contact open) or
– invert a control output.
IRIS-Net
DIGITAL MATRIX | en 515
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
