Editing TPI properties
Following table lists properties of the TPI-5 touch panel.
Property Range Description
Brightness 0 to 100 Display brightness, 0 = minimum brightness, 100 = maximum
brightness
Layer after screensaver
active
1 to 32 Enter the number of the layer to be displayed after the screen
saver was active.
Startup layer 1 to 32 Enter the number of the layer to be displayed after power-on.
Editing network settings
Default network settings of the TPI-5:
Parameter Value
IP address 192.168.1.102
Subnet mask 255.255.255.0
Gateway IP address 192.168.1.1
DHCP server off
1. Connect the network connection of your PC to the Ethernet interface of the TPI-5 with a crossover cable, or with a
patch cable and a hub/switch.
2. Activate the power supply system of the TPI-5.
After some seconds an IRIS-Net project signals the successful start activity of the TPI-5.
3. Start the IRIS-Net software on your PC.
4. Click on Tools > Device Scan.
The Device Scan dialog appears.
5.
Select the entry IRIS-Net TPI in the Device Type list.
In der Devices Liste werden alle gefundenen Touch Panels angezeigt.
IRIS-Net TOUCH PANELS | en 531
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
