Cutter Maintenance
¡
B-7
Replacing the Stylus Blade
At some point, especially after prolonged use with specialty tapes, you
may have to replace the stylus blade.
Step 1: Turn the power off, and open the printer. Follow the instructions in
Removing the Stylus Holder on page B-3.
Step 2: Holding the stylus holder in both hands as shown below, keep the nose
end of the mechanism stable and turn the other end counter-clockwise,
loosening it until the two parts separate.
Figure B-5. Detaching the stylus.
To Next Page
Loading...
Need help?
General
