53-1002177-19 Hardware Installation Guide
Brocade DCX 8510-4 Backbone Hardware Installation Guide
If there are other logical switches on your chassis, use the setcontext command to connect to all the other
switches and then run switchcfgpersistentdisable on these switches as well.
b) Power down the entire chassis.
6. Remove the screws from the WWN bezel on the back of the chassis. Pull the bezel away from the chassis and set it
aside. The two WWN cards are now visible.
Figure 62: Removal and replacement of the WWN bezel (logo plate) and WWN card
53-1002177-19
133
To Next Page
Loading...