172
OILING SYSTEM
OIL SUPPLY PRIMING
200 – 250 HP (3.3 L) MODELS
Start the outboard. Use th e oil priming function in
the sof tware to mak e sure the s ystem i s co m-
pletely primed.
Use the Prime Oil System button of the Dynamic
Test screen to prime the oil pump.
Observe oil flow through all oil distribution hoses.
Air must be purged during the priming procedure.
Make sure that oil flows through the rear oil distri-
bution manifold to the cylinder block fittings.
Small bubbles are accept able. Large bubbles
must be eliminated through continued priming.
Repair any fuel or oil leaks.
The oiling system on the se mod els can also be
primed using the Self-Winterizing featu re if diag-
nostics software is not availa ble. Refer to STOR-
AGE on p. 44.
Dynamic Tests Screen
1. Prime Oil System button
008570A
1. Oil distribution hoses 004224
1. Rear oil distribution manifold 008203
1. Oil distribution hose
2. Small bubbles
3. Large bubbles
004398
To Next Page
Loading...
