65
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
4
Dynamic Information
Dynamic information is viewed while the outboard
is running. Change s in dat a, such as voltages or
temperatures, are shown as they happen.
Occurred Service Codes (Faults)
Service codes are saved if an abnormal condition
occurs while the outboard is running.
The Occurred Faults scree n of the diagnostics
software shows the code number, the number of
times the event occurred, and operating hours of
first and last occurrences.
Active Faults
An active fault is a se rvice code th at cu rrently
exists. Active faults become occurred faults only if
the outboard is running.
Historical Faults
The Historical Faults screen keeps a history of all
previous occurred codes, including code number,
the number of times the event occurred, and oper-
ating hours of the last occurrence.
Historical faults cannot be erased.
Static Tests
Static Tests allow dia gnostic testing o f system
components while the outboard is NOT running.
Engine Monitor Screen 008566
Occurred Faults Review Screen 008584
Active Faults Review Screen 008585
Static Tests Screen 008569
To Next Page
Loading...
