273
MIDSECTION
EXHAUST HOUSING SERVICE
12
Tighten th e small a dapter to exha ust ho using
screws and nuts to a torque of 60 to 84 in. lbs. (7
to 9.5 N·m).
Exhaust Housing Assembly –
3.4 L models
Apply Adhesive 847 to the bottom flange of the
inner e xhaust ho using. In stall a ne w seal. Apply
Triple-Guard grease to outer seal surface.
Install gro mmet and wate r tube in the inn er
exhaust housing.
Clean an d d egrease t he a dapter hou sing an d
outer exhaust ho using matin g surface s with
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
Place the a dapter/inner e xhaust housing into th e
exhaust housing. Guide the water tube throug h
the hole in the outer housing.
13691
006984
1. Water tube grommet 006982
13692
006981
To Next Page
Loading...
