33
.ROUTINE SERVICE
COOLING SYSTEM
2
Tachometer Pulse Setting
Confirm accuracy of tachometer reading.
• Adjust dial on back of t achometer to required
setting (the outboard should not be running).
Water Pump Overboard Indicator
A steady stre am o f water should flow from the
overboard indicator.
Operating Temperature
An o utboard run at id le speed sho uld achieve a
temperature b ased on the engine’s thermostatic
control. In gene ral, the powerhea d temperature
should reach at least 104°F (40°C) after five min-
utes of idling. Check that the powerhea d reaches
idle temperature. Refer to SERVICE SPECIFICA-
TIONS on p. 10.
Idle Speed
Make sure the outboard idles within the specified
idle RPM ra nge. If the outboard is run on a flush-
ing device, the idle speed and quality may not be
representative of actual in water use.
COOLING SYSTEM
Check the con dition of cooling system compo-
nents regularly:
• water intake screens
• water pump
• all internal water passages
• thermostats
• all external water hoses and fittings
• vapor separator cooling passages and fittings
• EMM cooling passages and fittings
• overboard water pressure indicator.
Water Intake Screens
Inspect condition of water int ake scre ens. Clean
or replace as needed.
Confirm function of overboard water pressure indi-
cator.
Clean or replace plug and nozzle as needed.
Outboard Model Tachometer Setting
200–300 HP 6 Pulse or 12 Pole
1. Water pump overboard indicator 008469B
1. Water intake screen
2. Overboard water pressure
008470B
To Next Page
Loading...
