279
MIDSECTION
TILLER HANDLE SERVICE – LONG HANDLE
11
Coat bushing and washer with Triple-Guard
grease. Apply Nut Lock to threads of screw.
Install shift handle on tiller handle and tighten
screw to a torque of 18 to 20 ft. lbs. (24.5 to 27
N·m).
Install shift cable on shift pin with a new cotter pin.
Install shift cable retainer on shift cable trunnion.
Use a soft-faced mallet to install the inner handle.
Secure tab of the inner handle into the outer han-
dle. Tab must be flush with the back of the flange
and top of tab must be flush with top of flange.
Apply Nut Lock on the screw threads, install the
washer and screw.
1. Bushing
2. Washer
3. Screw
006717
1. Shift handle screw 006714
1. Cotter pin 006720
1. Shift cable retainer 006721
006680
1. Back of flange 006682
To Next Page
Loading...
Need help?
General
