Bruker B-ACS 60 - Page 44

44 (167) BRUKER Installation Manual Version 001
Software Commands
Barcode Option Commands
Table 7.2. Bar Code Option Commands
Instruction: BD (Barcode Digit)
Format: BD XX<CR>
Description: Set barcode digit length to 4, 6 or 12 digits
Reply: <CR><LF>
______________________________________________________________
Instruction: BS (Barcode Status)
Format: BS <CR>
Description: Report of the selected barcode digit length and the associated
code type.
Reply: BD 4<CR><LF>
BD 6<CR><LF>
BD 12<CR><LF>
______________________________________________________________
Instruction: CL (CLear)
Format: CL XXX<CR>
Description: Clear label entry for position XXX.
Reply: <CR><LF>
______________________________________________________________
Instruction: EX (EXperiment number)
Format: EX XXX<CR>
Description: Report experiment for sample in position XXX.
Reply: E<number><CR><LF> if the reading was correct.
E0<CR><LF> if there was a reading error.
______________________________________________________________
Instruction: LL (Load Label)
Format: LL<CR>
Description: Read labels from actual reader position.
Reply: <CR><LF>
______________________________________________________________