Bruker SampleXpress - Adding;Replacing Samples in Sequence; Figure 9.21 Removing Samples in Sequence from Position

73
Z31900_00_01
Operation
4. When all samples have been inserted, press the Back button to return to the main
menu.
9.5.1.2 Adding/Replacing Samples in Sequence
This functions allows samples to be added or replaced sequentially in ascending order,
until the Back button is pressed.
Figure 9.21 Removing Samples in Sequence from Position
1. Press the Add button (Figure 9.16) in the main screen.
 The Add selection screen is displayed.
2. Press the In sequence from position button.
 The Position selection screen appears.
3. Select an empty gray position for adding a sample or a filled position for replacing.
4. Add the sample to the position selected.
 The chain rotates in ascending order to the next position, whereas another sample
can be added or replaced.
Use the Skip Sample button to skip a sample. Use the Back button to return to the main
menu.