107
Z31900_00_01
Troubleshooting
Improperly Executed Troubleshooting Procedures
Moving Parts
Behavior in the Event of Faults
The following principles apply:
1. Immediately initiate an emergency stop in the event of faults posing an immediate
danger to people or property.
2. Ascertain the cause of the fault.
3. If fault rectification requires work in the danger zone, shut down the device and
secure to prevent restarting.
4. Immediately notify those responsible at the place of use about the fault.
5. Depending on the nature of the fault, have it rectified by authorised specialised per-
sonnel or rectify it yourself.
WARNING
Danger of injury from improper troubleshooting!
Improperly executed troubleshooting work may result in serious injury and significant
damage to property.
f Ensure sufficient assembly space before starting work.
f Pay attention to orderliness and cleanliness in the assembly location! Loosely
stacked or scattered components and tools could cause accidents.
f If components have been removed, pay attention to correct assembly, refit all fix-
ing elements and comply with bolt tightening torques.
f Before the restart, ensure that
- all troubleshooting work has been carried out and completed in accordance
with the information and instructions in this manual.
- no persons are in the danger zone.
- all covers and safety devices are installed and functioning properly.
CAUTION
Accident hazard from movement of mechanical parts!
The fingers or hand may be pinched due to movement of mechanical parts.
f Shut off the SampleXpress before accessing the device.
To Next Page
Loading...
