Bruker SampleXpress - Removing All the Samples; Figure 9.25 Remove Sample Screen; Figure 9.26 Operator Access Position

75
Z31900_00_01
Operation
 When the sample arrives at the Operator Access Position the following message
is displayed:
Figure 9.25 Remove Sample Screen
4. Remove the sample from the Operator Access Position.
Figure 9.26 Operator Access Position
 The selection screen (Figure 9.11) will be displayed again.
5. To finish this function:
f Press the Back button,
or
To remove another sample,
f Press a white position.
9.5.2.1 Removing All the Samples
To remove all the samples individually through the Operator Access Position.
1. Press the Remove button (Figure 9.16) in the main screen.
 The Remove selection screen is displayed.