BT Micro Owner’s Manual
115
are required, then the Output Code would typically match the
Input Code.
If you require to enter a network operator specific access code
(sometimes referred to as an Indirect Access Code), enter this
before the relevant dialled digits in the ‘Output Code’ field. The
‘Output Code’ entered will be dialled automatically by the
system on front of the user dialled digits.
Preferred /Exclusive
In Preferred is selected (then the system will, as a Preference,
route the call using the line(s) which have been Enabled for
each specific Input Code. However, if these line(s) are busy or
not-available, then the system will attempt to route the call over
any of the remaining system lines (i.e. those which are not
Enabled for that specific Input code). If Exclusive is selected the
route the call over the selected lines and if they are busy or not
available busy tone will be returned.
LCR Timebands
The option to turn Least Cost Routing on and off automatically
is also provided. Select Enabled for programmed LCR
timebands and select Next. The following page is displayed: -