BT Micro Owner’s Manual
20
Attaching the Featurephone desk plinth
The desk plinth allows you to mount the featurephone at two
angles.
Wall-mounting a Featurephone
The phone plinth is inverted on the base to wall mount the
phone.
Locate, drill and plug the 2 screw locations as shown below.
The holes should be deep enough to accept a 2.5 cm screw.
Insert the two screws leaving sufficient space to clip the base
over them. Locate the phone and base over the screws.
Wall mount Plinth position
Plinth position 20
Plinth position 35
Line cord rails
To Next Page
Loading...