BT Micro Owner’s Manual
49
Featurephone– Basic Call Features
Making and Answering Calls
Making an external call.
There are two basic modes of operation available for making
external line calls. In the normal mode, which is the default, a
line access digit (9 or 8) is dialled to select a line.
If Automatic Line selection is programmed you do not enter the
line access code. See page168 for Automatic Line selection
programming from a featurephone and page 100 for
programming via the web management interface.
Making an external call in normal mode
1. Press the Line Key 1 for Line 1and dial the external
number. The other keys may be programmed with the IP
lines if equipped. See Key programming on Page 44.
Or
2. Dial 9 (to select Line 1, the standard line) or Dial 8 (to select
an IP line). When dial tone is returned dial the external
number.
Making an external call with Automatic Line selection
programmed
1. Press the Line Key 1 for Line 1 and dial the external
number. The other keys may be programmed with the IP
Lines if equipped. See Key programming on Page 44.
Or
2. Lift the handset, or use the Hands-free Key, and dial the
external number. The system automatically selects a free
line and the number is dialled.
Making an external call in Pre-dial mode
If you do not lift the handset you may enter digits in Pre-dial
mode by dialling 9 or 8 followed by the external number in
normal mode or dial the external number when Automatic Line
selection is programmed. Digits will not be sent to line until you
lift the handset, press the Hands-free key, or select 'Dial' from
the display.
You can edit the number you have entered prior to sending
to the line, by using the left-hand Keypad ‘Edit Key’, located
below the keypad.
To make an internal call in normal mode
You can place an internal call in one of the following ways:
1. Select the ‘Internal Call’ option on the display and select the
desired extension from the list
2. Dial the extension number (20 – 23 or 31-34) and select
'Dial'.
3. Lift the handset and dial the extension number.
The display will show the extension number, or, if programmed,
the extension’s name.
To Next Page
Loading...
Need help?
General