BT Micro Owner’s Manual
44
To program a feature onto a Programmable Key on your
extension
You may re-programme any or all of the Programmable Keys
located on the featurephones. There are eight keys on the V8.
You can programme these keys to select lines, extensions,
features or speed dial numbers.
From your featurephone, press the PROGRAMME Key
Press the Scroll Down Key () until ‘Key Programming’ is
displayed.
Select ‘Key programming’.
Press the Programmable Key to be programmed. A list of
options appears on the display.
Select the required feature to be programmed onto the key.
Use the Scroll Down Key () to scroll down to view the list of
available features. For example, to programme the key with a
speed dial number, select the ‘Individual digits’ option.
Press the Hands-free Key to finish programming.
Note
If you are programming the key to call an external number
remember to precede the number with a 9 to select the analogue
line or 8 to select an IP Line.
To turn on Headset Mode
When a headset is plugged in to the headset socket it is
automatically detected and the option to turn the Headset mode
on is displayed on the display. You can also turn Headset mode
on and off via the PROGRAMME Key
From your featurephone, press the PROGRAMME Key
Press the Scroll Down Key () until ‘Headset Mode’ is
displayed.
Select ‘Headset mode’.
Select the required option – ‘Headset on’ or ‘Headset off’. Once
selected, the display will show ‘Headset On’ or ‘Headset Off’
and then revert to the Idle Menu.
Press the Hands-free Key to finish programming.
The handset does not operate in Headset Mode.
To set a ringing tone on your featurephone
You can select one of six ringing tones.
From your featurephone, press the PROGRAMME Key
Press the Scroll Down Key () until ‘Ringing options’ is
displayed.
Select ‘Ringing options’.
Select ‘Tone 1’, ‘Tone 2’, ‘Tone 3’, ‘Tone 4’, ‘Tone 5’ or ‘Tone 6'
which will cause the selected tone to sound.
Select ‘Confirm’ to use the chosen tone. On the display ‘Ring
type set’ will appear and then the display will revert to the Idle
Menu.
Press the Hands-free Key to finish programming.
To set the display contrast on your featurephone
You may choose from four levels of display contrast.
From your featurephone, press the PROGRAMME Key
Press the Scroll Down Key () until ‘Contrast options’ is
displayed.
Select ‘Contrast options’.
Select ‘Level 1’, ‘Level 2’, ‘Level 3’ or ‘Level 4’ to set a contrast
option. The prompt ‘Contrast set’ appears on the display.
Press the Hands-free Key to finish programming.
To Next Page
Loading...
Need help?
General