BT Micro Owner’s Manual
59
Using a Standard or DECT Cordless Telephone
Feature Access Code List
You may access the range of BT Micro features with a standard
or cordless telephone. To use a feature, dial the appropriate
code from the list below. (In the table, R means the Recall
Key).
If your telephone is equipped with memory keys you may
programme feature codes onto the keys - refer to your
telephone user guide for instructions. On the DECT cordless
phone you can programme codes under the Services (SER)
key. See Page 159.
Feature Code Feature Code
Answering machine on/off 737 Incoming call Divert on Busy 793
Alarm Call 718 Incoming call Divert on No Answer 794
Alarm Call cancel 718* Internal Call Waiting R8
Call Pick-up 727 Night Service 738
Call Waiting Tone Protection 725 (R725) Open the Door 731
Conference R3 Page – featurephones 716
Divert All 732 xx Park R712
Divert on Busy 733 xx Pick up parked call 712
Divert on No Answer 734 xx Redial 77
Do Not Disturb – set/cancel (Not available to
extension 20,)
736 Redial IP call over standard line R77
Door Open 731 (R731) Reset telephone 739
Extensions - Wired 20-23 Return to call placed on systemhold 719
Extensions - Cordless 31-34 Return and hold in Two Call handling R2
Extension 20 0 Return and release in Two Call handling R1
Extension Lock – change code
714 xxx Ring Back R5
Extension Lock - lock/unlock 713 xxx Saved Number Redial 781-785
External Call Hold R Speed Dial – accessing personal numbers 74(01 -30)
Follow Me 735 (Password)
xx
Speed Dial – accessing system numbers 400-499
Forward Recall R722 Speed Dial – programming personal numbers 75(01 -30)
Intrude 709 System voicemail box on/off 737
Line Access – Analog lines 9 Voice call (to page an individual featurephone)
715
Line Access – IP Lines 8 Voice Mail Access
*
Incoming call Divert All Calls 792 Voice Mailbox number 710
Making External Line Calls
There are two modes of operation available for making external
calls. The normal mode, which is the default, a line access digit
(9 for Line 1or 8 for an IP line) is dialled to select a line. If
Automatic Line selection is programmed you do not enter the
line access code. To programme Automatic Line selection from
the featurephone see page 168and for programming from the
Web Interface see page 100.
To make an external call in normal mode
1. Lift the handset, or use a Hands-free Key, if available on
your telephone. On the DECT phone press .
2. Obtain a free line in one of the following ways:
3. Dial 9 to select Line 1.
To Next Page
Loading...
Need help?
General