BT Micro Owner’s Manual
17
Cabling Standard telephones
Standard telephones can be connected directly to the system
using the telephone cord. If you wish to locate the phone further
away from the BT Micro you can do so by running telephone
cable and using telephone sockets.
It is recommended that BT Master sockets are used and that
the same cabling for featurephones above is used.
However two alternatives are also available
Using a Master socket at the phone a single pair (two
wires) can be used to connect between the sockets.
Using a slave socket at the phone it is necessary to run
three cables between the sockets.
Connection with a Master socket
Connection with a Slave socket
To Next Page
Loading...
Need help?
General