BT Micro Owner’s Manual
12
2. Plug the ADSL cable (purple) into the DSL socket on the back
of the BT Micro.(Marked in purple)
3. Plug the Line 1 into the phone connector and the ADSL
cable into the ADSL connector on the splitter and plug
the splitter to the BT wall telephone outlet.
4. Connect the power supply between the BT Micro and
mains power outlet.
5. After approximately 30 seconds, you will be able to
make telephone calls.
6. Register your DECT Cordless phones
Press the ‘Page’ button for 4 seconds. This button is
located on the front of the BT Micro unit. This places
the system in registration mode for 30 seconds. The
Power LED flashes red when in registration mode.
Select ‘REG’ on the DECT phone.
Press OK for ‘REGISTER’
Enter 1234 as the PIN.
The phone will register to the BT Micro as Handset 1
(extension number 31).
You can register more than one handset in the 30
seconds that the system is in registration mode. The
sets are automatically allocated a Handset number
(1-4) and use extension numbers (31-34).
Note
After powering on the DECT telephone(s) for the first time, the
batteries should be initially charged for 14 hours to get maximum
battery performance
Connecting PC(s) and configuring the BT Micro for Web
Browsing
1. Connect the yellow LAN cable from the LAN port of your
PC to any of the Ethernet ports (marked in yellow)
To Next Page
Loading...
Need help?
General