BT Micro Owner’s Manual
153
13 Reset to Defaults
This page allows you to reset your BT Micro to its default factory
settings.
The configuration settings of your BT Micro are stored in a
configuration file. When you set up your BT Micro and access
the web pages for the very first time, the configuration file
contains a default factory configuration. This configuration has
been set by your provider for you, and contains the basic
settings that you can use without having to make extensive
changes to the configuration.
If you do make changes to the default configuration but then
wish to revert back to the original factory configuration, you can
do so by resetting the BT Micro to factory defaults.
You may need to reset to defaults if you have made changes to
BT Micro's settings causing it not to function properly.
If you are having problems connecting to your Internet Service
Provider, their support staff may request that you reset to
defaults to help in the connection process.
Remember that all your previous settings will be replaced.
Resetting to Defaults
Note
If you reset your BT Micro to factory defaults, all previous
configuration changes that you have made are overwritten by the
factory default configuration.
1. From the left-hand menu, click on Reset to Defaults. The
following page is displayed:
2. This page reminds you that resetting to factory defaults
cannot be undone – any changes that you have made to
the basic settings will be replaced. If you are happy with
this, click in the Confirm box to tick it, then click Reset to
Defaults. The following page is displayed:
To Next Page
Loading...
Need help?
General