BT Micro Owner’s Manual
184
Enter the System Programming Password and select
‘Extensions’.
Press the Scroll Down Key () until ‘Open door restriction’ is
displayed.
Select ‘Open door restriction’.
Select which extensions are restricted from opening the door.
The extensions restricted from operating the Doorstrike will be
indicated with a .
Press the Hands-free Key to finish programming.
External Diversion Options
This allows you to decide if External callers or External and
internal Callers to your extension are diverted externally if you
have set an external divert. It also allows extensions to be
prohibited from activating an external diversion.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select
‘Extensions’.
Press the Scroll Down Key () until ‘External Diversion' is
displayed.
Select 'External diversion'.
Select ‘No trunk to trunk calls’.
Select the extensions that are not allowed to activate an
external diversion or set up trunk to trunk calls.
If both internal and external calls are to be diverted select 'All
calls'.
If external calls only are to be diverted select 'External calls only'
Miscellaneous system configuration options
To change the Programming Extension
System programming can only be carried out at one
featurephone, that is, the featurephone connected to the
Programming Extension. By default, extension 20 is the
Programming Extension. The Programming Extension can be
changed to any other extension if required.
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘System’.
Select ‘Programming position’.
Select the extension you wish to have as the Programming
Extension. The selected Programming Extension is denoted by
a .
Press the Hands-free Key to finish programming.
To change the System Programming Password
The default System Programming Password (1111) can be
changed to any 4-digit number.
To Next Page
Loading...
Need help?
General