BT Micro - Adding and Removing DECT (Cordless) Extensions

BT Micro Owner’s Manual
177
Enter the number to be dialled. If you wish to dial an external
number, enter 9, or another Line access code, before the
external telephone number, to select a Line.
Press the Hands-free Key to finish programming.
Note
When a featurephone is programmed as a Hot Line, no other
facilities can be invoked after it is programmed. As soon as you
go off-hook on the featurephone, the number is dialled..
Note
A common application for the Hot Line feature is for a fax or
modem. The extension can be set to automatically select an
exchange Line so the fax or modem does not have to dial 9.
Adding and removing DECT (Cordless) extensions
You can register up to four DECT cordless handsets or remove
already registered handsets
To register a DECT handset
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select
‘Extensions’.
Select ‘Handset Registration’
Select ‘Add a Handset’
The system is placed in handset registration mode. The power
led flashes red and green.
Select ‘REG’ on the DECT phone.
Press OK for ‘REGISTER’
Enter 1234 as the PIN.
The phone will register to the BT Micro.
To un-register a DECT handset
From the Programming Extension, press the PROGRAMME
Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select
‘Extensions’.
Select ‘Handset Registration’
Select ‘Remove handset’
The registered handsets are indicated with a . Select the
handset to be removed.
Assigning Extension Names
You may assign names to extensions. When an extension
receives an internal call, its display will show the calling
extension name in the place of the calling extension number.